Delivery in disassembled state, packaging - 2 places:
• place 1 of 2 (upper part of the body)
1845х520х102, gross of 37.6 kg;
• place 2 of 2 (stand)
820x545x177 mm, gross 18.5 kg
Drying cabinets of HOTBOX-2000N models are designed for drying wet clothes and shoes, pre-wringing is not required.
Structurally, the cabinet consists of two basic elements: the upper part of the cabinet body and the lower stand with a built-in heating unit. The upper part of the body is connected to the stand by means of standard hardware.
The upper part of the body is closed by two doors, one of which has a postal lock that locks both doors at the same time. Inside, the upper part of the body is equipped with six removable meshy shelves. One can put mittens, hats or shoes on the shelves for drying. Clothes hangers can also be hung on the meshy shelves.
The upper part of the HOTBOX-2000N model’s body and the lower stand with a built-in heating unit are made of stainless steel, resistant to wet environments, allowing wet cleaning without the use of detergents. Attention! The products are NOT intended for use in aggressive environments.
There is an air outlet in the cabinet cover. А flange for connection to an external ventilation system is included.
The lower stand of the cabinet is a welded structure made of sheet steel and is the base element on which the cabinet is assembled. There is a built-in heating unit inside the stand body.
The heating unit consists of: cross fan, needle mica heater, temperature control sensor and electronic control unit. Control buttons, light and digital indication of operating modes are located on the front side of the cabinet cover. As a protection against overheating, a hot-melt fuse is used (without return to the initial point).
Technical characteristics of the HOTBOX-2000N models
|Overall dimensions (height, width, depth)||1818×800×515*mm|
|Number of removable meshy shelves in set||6 pcs.|
|Maximum shelf load||10 kg|
|Number of crossbars for hanging body armor||2 pcs.|
|Maximum load on the crossbar for hanging body armor (for the SHSO-2000B model)||60 kg|
|Diameter of the flange for air removal to the external hood||120 or 125 mm|
|Stainless steel grade (for SHSO-2000N model)||AISI 430|
|The length of the power cord||2.5 m|
|Cabinet grounding||through the ground wire and the ground contact in the plug of the power cord.|
|Power capacity of a cross fan||300 m3/h|
|The power of the motor cross fan||53 W|
|Type of heating element||needle mica|
|The power of the heating element||2000 W|
|Mode of operation||
|Timer with configurable automatic shutdown setting||
|Overheating protection||hot melt fuse (no return to initial point)|
|Net weight of HOTBOX-2000N||50.2 kg|
* without air outlet flange