Home / Catalog / Drying cabinets / HOTBOX-22M-600


Dimensions, HxWxD: 1962 х 602 х 513* mm
Weight: 47,5 kg

Delivery in disassembled state, packaging - 2 places:
• place 1 of 2 (upper part of the body)
1785x520x102, gross 33.1 kg;
• place 2 of 2 (stand)
620x595x230 mm, gross 17.5 kg

Drying cabinets for clothes of HOTBOX-22M-600 models are designed for drying wet clothes and shoes, pre-wringing is not required.

Structurally, the cabinet consists of two basic elements: the upper part of the cabinet body and the lower stand with a built-in heating unit. The upper part of the body is connected to the stand by means of standard hardware.

The upper part of the body is closed by two doors, one of which has a postal lock that locks both doors at the same time. Inside, the upper part of the body is equipped with six removable meshy shelves. One can put mittens, hats or shoes on the shelves for drying. Clothes hangers can also be hung on the meshy shelves.

There is an air outlet in the cabinet cover. А flange for connection to an external ventilation system is included.

The lower stand of the cabinet is a frame structure consisting of front and rear panels made of sheet steel, two side and one lower frame made of shaped pipe. The front panel has a built-in heating unit.

The heating block consists of: a cross fan, a needle-shaped mica heater and electronic control unit. Control buttons and light indication of operating modes are located on the front side of the heating unit. As a protection against overheating, a hot-melt fuse is used (without return to the initial point).

The frame design of the lower stand enhances the strength and rigidity of the cabinet, which makes it possible to carry or move it, in addition, the open space on the sides makes it possible to clean the floor under the cabinet.


Technical characteristics of the HOTBOX-22M-600 models

Overall dimensions of HOTBOX-22M-600 (height, width, depth) 1962х602х513*mm
Number of removable meshy shelves in set 6 pcs.
Maximum shelf load 10 kg
Number of adjustment feet in set 4 pcs.
Diameter of the flange for air removal to the external hood 120 or 125 mm
The length of the power cord 2.5 m
Cabinet grounding through the ground wire and the ground contact in the power cord plug
Supply voltage 230V/50Hz
Power capacity of a cross fan 150 m3/h
The power of the motor cross fan 34 W
Type of heating element needle mica
The power of the heating element 1600 W
Mode of operation
  • drying without heating;
  • heating at 50% power;
  • heating at 100% power;
  • cooling mode of the heating unit for 1 minute when switched off
Timer with fixed automatic shutdown setting
  • automatic shutdown after 4 hours;
  • manual shutdown (no timer)
Overheating protection hot melt fuse (no return to initial point)
Net weight of HOTBOX-22M-600 47,5 kg

* without air outlet flange and without adjustment feet